Renovation and construction of all

Laying laminate can be produced independently, unless of course follow a few practical tips, as well as carefully reading the instructions that came with the laminate.

Let us dwell briefly on the types of laminate on moisture-resistance:
Not waterproof - you can not wash, it is important not price, and the manufacturer and quality.
Waterproof - can handle much wrung out a rag and not often.
Water resistant - can withstand frequent washing, but the class of 33 and 34 of the most expensive.

Started laying to estimate the number of square meters. meters of flooring, color, and durability (lifetime). To the end of the work does not upset the results of their work, be sure to pay attention to the sexual basis, it can be different, wood, cement screed, or other, it is important that it is flat and dry. When laying, use a wooden hammer to fit the series and fixing locks. Do not try to drive the locks with full force and with a metal hammer - screw up the panel.

Lay laminate should start from the door. Necessary, starting work, to adhere to certain conditions, room temperature is not below 18 degrees, humidity is not higher than 60-70%. During the installation is not aired. When laying laminate width of the last panel must not be less than 5 cm is better to cut the first sheet. Sex and the baseboard is not in no case shall be securely fastened to the base of any glue or nails. Since this material tends to "breathe".

Lay laminate should start from the door. To take into account the light and shade, the panel should be laid longitudinal stripes in the direction of illumination. Around the perimeter of the room between the wall and laminate strips leave a gap of 10 mm. The main thing is not to bend the rows and stacked properly install locks. It is important that the heating risers got to the center between the stacked strips of laminate. And do not forget to normal clearance around the riser, this condition does not allow the voltage to appear between the panes. Starting installation of panels, placing, and docked the first couple of pages, the picture becomes clear and the next result.

So good luck and patience. And all will turn out.